Quick Details:1. Name: 25 pair modular splicing rig (3M type)2. Mode No.: YH-Z90153. Place of origin: Zhejiang,Website:http://www.ftth-network.com, China4. Packaging: Metal box/set， Neutral carton/set.5. CTN: 82x25x25cm6. GW: 23kg7. Certificate: ISO9001Descriptions:The module pressing-connecting tool is a necessary tool used to perform press and connection of 25 derection connection, duplicate connection, half-branch connection and cross connection modules.The tool is portable and suitably usde to install underground and overhead cables and cross connection boxes of floor or pole-fixed types both indoors and outdoors.Details: Appearance: Smooth surface, no flash, no glitches, no sagging surface coating, spray leak phenomenon, zinc coating line with GB9793 standard. 2. Dimension: Stent tube length: 750 ± 10mm Splice head interior wall width: 166 ± 1mm Beam line frame height: 160 ± 5mm Splice head height: 288 ± 5mm Crimp the inner will face in: 181 ± 1mm Metal box size: 800x200x200mm 3. Beam line stent frame and working conditions should be attached firmly under the three non-slip phenomenon. 4 pump working pressure: 18-25Mpa 5 Start the pump handle and flexible, no wiring. 6 should be no leakage pump seal wellStandard configurations:Wire connecting frameHydraulic systemPressing connecting headInstallation toolsDouble connection headTest clamp, opening pliersButtoning up devicesTransversely moving poleTools box and test combReal shot: