Model NO.: KBW-60Working Pressure: 6-10 BarMax. Inlet Temp.: ,50 OcAir Vonnections: DN100Dimensions:2200 mm (L) X1000 mm (W) X2875 mm (H)Trademark: YUANDAOrigin: ZHEJIANG CHINACapacity: 66Nm/MinPower: 220V/1pH/50HzWeight: 2650 KgInlet Oil Content: 0.1mg/ M3Specification: ISO, CEHS Code: 8414809090Product DescriptionExternally heated regenerative desiccant air dryer is developed based on the successful design of the heatless type and heated type desiccant air dryers. The purge air is pre-heated before regeneration to reduce its required capacity in order to achieve an energy saving. It avoids the disadvantage of short switching period of heatless type desiccant air dryer, and at the same time it consumes much less heating energy like heated type desiccant air dryer. This is the energy saving desiccant air dryer you can rely on!Working principleThis series of desiccant dryer incorporates the working principles of pressure swing adsorption and temperature swing adsorption. Desiccant absorbs water moisture in drying column and being regenerated with high quality dried and heated purge air in regeneration column by air thermal diffusion and high pressure difference mechanisms.heatless  regeneration  compressed  air  dryer  is  based  on  the principle of PSA, use porous desiccant to adsorb water molecules for compressed air. drying the Technical Features + Imported PLC intelligent controller, stable and reliable.+ Flange filling mouth, easy replacement. + Unique endoscopy design, easy supervise for operation. + Advanced pneumatic valve ensure more than one million times of continuous use . + Special airflow diffuser to ensure the using life of the desiccant.Technical Data+  Working  Pressure:  0.4～1.0MPa（1.0～3.0MPa is available）+  Dew  Point: -40℃（-40℃～-73℃MPa is available）+  Inlet  Air  Temperature: ≤50℃+  Regeneration  Gas  Consumption:≤12%+ Pressure Loss:≤0. 02MP+ Operating cycle : 4～10 min